KRUUSE Rehab karpalledskydd svart M 1st (272162) - KRUUSE karpalledsskydd |


KRUUSE Rehab karpalledskydd svart M 1st


Karpalledsskydd för ytterligare stöd av leden, exempelvis efter försträckning, snedvridning eller efter ett kirurgisk ingrepp i leden, som inte kräver gipsning, eller i fall där gips avlägsnats.
Material: Neopren med inlägg av plaststöd (turbocast) som är formbart i värme.
För instruktioner om hur denna skall formas se ytterligare info och video under specifikationer.

KRUUSE Rehab karpalledskydd svart M 1st

The carpal joint protector can be adjusted individually to any type of dog. This adjustment should be carried out by your veterinarian. The protector should be applied in cases where extra support of the joint is needed, e.g. following spraining, straining, or following surgical procedures, which do not require a cast, or subsequent to removal of cast and in any other cases, in which only a light support is required. Should be applied during training and subsequently removed when the dog is resting indoors. As the carpal joint protector is individually shaped, the dog owner can easily apply and remove the protector at home without professional assistance.

Immerse the protector (do not remove the plastic insert) in boiling water for 30 seconds. This will soften the plastic and make it pliable. Remove excess water bygently squeezing the water out of the protector with a towel. When excess water has been removed and the protector has cooled down, the fitting of the protector to the animal’s leg can proceed. The dog’s leg must be stressed at a physiological angle during fitting. The opening with the protective dressing must be placed directly on the small pad at the back of the front leg. Fasten the protector to the leg with the Velcro tape. Occasionally the material can bulge out through the Velcro fastenings and a more optimal fitting can then be achieved by wrapping a Vet-Flex bandage around the protector. After ten minutes the plastic insert will be set in a perfect fit around the leg, and the Vet-Flex bandage and the protector can be removed. Let the protector dry in the moulded shape for a minimum of sixty minutes. Avoid handling the protector during this period. When the protector has dried sufficiently you will have an individually shaped carpal joint protector.

In case the protector gets soiled on the inside, it must be cleaned to avoid abrasions. To clean the protector, simply brush off any dirt. The protector can also be hand washed at 40º C with a mild detergent. If the protector looses its shape subsequent to washing it can be reshaped according to the above-mentioned directions. However, in order to achieve the optimal fit the protector should be reshaped by your veterinarian. The protector can be reshaped several times.

XS, Carpal joint protector Cocker Spaniel, Whippet 272159
S, Carpal joint protector Collie, Springer Spaniel 272161
M, Carpal joint protector Labrador, Dalmatian 272162
L, Carpal joint protector Rottweiler, German Shepherd 272163
XL, Carpal joint protector Bernese Mountain Dog 272164

Alternativa produkter


Relaterade produkter

KMR/Esbilac alternativ